Thursday, August 10, 2017

Composting Toilet


Ken and Heidi Maitland, Victorious, 37VT26, have solar panels and enjoy being on a mooring and anchoring out. Having a composting toilet allows them to be more self-sufficient. This also solves the problem of finding pump outs. On their long voyage last winter they found many times that they were out of service at marinas and gas docks. This prompted them to replace their conventional toilet during the trip.

In their own words
We have used both main types of composting toilets: Air Head on their LNVT, and Nature's Head on their previous boat. Both types have a mostly pleasant odor, which is the smell of peat moss used in the toilet tank. There have been a few situations when the composting toilet didn't work as designed and can be traced to use by a visitor who did not follow the simple directions (in our case, children). Check the manufacturer's comments on-line for dumping the contents.

INSTALLATION: For the shelf it sits on: make a cut out wide enough for the toilet and the crank handle; for us we lowered the base 6"  (still about 3-4" above the floor of the head).  If you lower the base more, the whole toilet moves more into the center of the head because of the turn of the hull in the head. There is a new vent hose that runs up the head inside the port wall and we added a clamshell vent outside just forward of the head port.


After lowering the shelf, it is just a matter of bolting the composting toilet down and removing the hoses to the holding tank. Plug and cap the short length of hose a couple of inches at the holding tank end and plug and cap after the vented loop at the sea cock end. Note: we intend to remove the holding tank and the seacock but our job was done while we were cruising in Florida and we were in the water and had time constraints.


LESSONS LEARNED: make cuts to the old shelf in such a way that the remaining shelf can be trimmed with teak. We made some rounded cuts and are finding that trimming the new straight edges is not a problem but the rounded edges will be difficult!

Galley Sink Faucet


Allan and Sally Seymour aboard Sally W, 37LNVT42, needed to replace their galley sink faucet. They found this Moen pullout spray faucet from the Renzo collection in spot resistant stainless steel finish. A shiny chrome finish is also available. They like the joystick feature and the fact that the faucet arm is a good length for extension over the sinks; but not too far. It's available on Amazon: https://www.amazon.com/dp/B004462XYM/ref=cm_sw_r_em_apip_y6YmLVvc6M87x